faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
faq [2020/04/27 09:43] – ivan | faq [2020/05/18 11:05] – ivan | ||
---|---|---|---|
Line 247: | Line 247: | ||
The '' | The '' | ||
+ | |||
+ | ++++ | ||
+ | |||
+ | ++++ Why is the tool change macro M6 not working? | | ||
+ | |||
+ | Check that the M6TXX tool change commands are accepted by the myCNC software (Settings > Config > G-codes settings > Tool Change M6TXX): | ||
+ | |||
+ | {{:: | ||
++++ | ++++ |
faq.txt · Last modified: 2024/02/20 10:07 by ivan