mycnc:alarms
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:alarms [2018/07/22 10:49] – pupalaiser | mycnc:alarms [2021/10/06 09:49] – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
**Alarms** | **Alarms** | ||
- | This section allows you to specify the alarm inputs and the response to these sensors. | + | * This section allows you to specify the alarm inputs and the response to these sensors. |
- | {{:mycnc:imput.png|}} | + | {{:mycnc:alarms-002-main-window-description.png}} |
- | The selected sensor is activated by setting the " | + | |
- | {{:mycnc:imput3.png|}} | + | * The selected sensor is activated by setting the " |
- | The input number on the controller board is set in the corresponding field " | + | {{:mycnc:alarms-003-sensor-name.png}} |
- | Numbering of inputs can be found in the documentation for the selected window controller. | + | |
- | {{:mycnc:imput4.png|}} | + | * The input number on the controller board is set in the corresponding field " |
- | The type of the sensor is specified in the corresponding field "" | + | {{:mycnc:alarms-004-input-number.png}} |
- | There are two types of input sensors. Normally open - the sensor in the rest position has not closed | + | |
- | {{:mycnc:imput5.png|}} | + | * The type of the sensor is specified in the corresponding field "" |
+ | {{:mycnc:alarms-005-sensor-type.png}} | ||
+ | |||
+ | * Additionally, | ||
+ | {{: | ||
+ | You can read up more on Software PLC programming here: | ||
__//Table of alarm sensors//__ | __//Table of alarm sensors//__ | ||
Line 31: | Line 37: | ||
|Shpindle Driver Ready|The spindle driver is ready for operation. This sensor is usually installed directly in the spindle drive, but it can also be done on its own.| | |Shpindle Driver Ready|The spindle driver is ready for operation. This sensor is usually installed directly in the spindle drive, but it can also be done on its own.| | ||
|Servo Driver(s) Alarm|Accident of any of the drives installed on the machine. As a rule, the signal of an accident is directly the drive of the engine.| | |Servo Driver(s) Alarm|Accident of any of the drives installed on the machine. As a rule, the signal of an accident is directly the drive of the engine.| | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
mycnc/alarms.txt · Last modified: 2021/10/06 13:42 by ivan