myCNC Online Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Change IP Address for TinkerBoard SBC =====

1. Open **Konsole** (Click on **Konsole** Desktop shortcut or select Menu -> Application -> Terminal Emulator)
{{tinker:mycnc-tinker--11.png}}
{{tinker:mycnc-tinker--12.png}}

2. Open Network settings in editor with Administrator permissions. Type in the konsole
<code>sudo  mcedit  /etc/network/interfaces</code> and press Enter.
{{tinker:mycnc-tinker--16.png}}
{{tinker:mycnc-tinker--17.png}}

There are 2 IP addresses setup on the Tinkerbboard by default
<code>
192.168.1.50
192.168.4.50
</code>

Configuration sections are<code>
iface eth0 inet static
#    address 192.168.0.50
    netmask 255.255.255.0
    address 192.168.1.50

iface eth0 inet static
    address 192.168.4.50
    netmask 255.255.255.0
    </code>

{{tinker:mycnc-tinker--15.png}}

Symbol "#" is used as a line comment.

3. Edit **Address** to fix LAN IP Address as you need. Press **F2**, **Enter** keys to save changes. Reboot computer.
{{tinker:mycnc-tinker--18.png}}


| We noticed that \\ the last address only is configured if LAN connector is disconnected from Network while computer boot. \\ All IP addresses in the **interfaces** configuration file should be set up correctly if LAN connector is connected to Network while booting. We don't know if this is a bug or "feature", just share this information. |