User Tools

Site Tools


mycnc:change_ip_address_for_tinkerboard_sbc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mycnc:change_ip_address_for_tinkerboard_sbc [2018/03/31 14:20]
skirillov
mycnc:change_ip_address_for_tinkerboard_sbc [2018/03/31 14:21] (current)
skirillov
Line 35: Line 35:
  
  
-| We noticed that \\ the last address only is configured if LAN connector is dicsconnected ​from Network while computer boot. \\ All IP addresses in **interfaces** configuration file should be setup correctly if LAN connector is connected to Network while boot. We don't know if this is a bug or "​feature",​ just share this information. |+| We noticed that \\ the last address only is configured if LAN connector is disconnected ​from Network while computer boot. \\ All IP addresses in the **interfaces** configuration file should be set up correctly if LAN connector is connected to Network while booting. We don't know if this is a bug or "​feature",​ just share this information. |
  
  
  
mycnc/change_ip_address_for_tinkerboard_sbc.txt ยท Last modified: 2018/03/31 14:21 by skirillov