mycnc:change_ip_address_of_mycnc_control_board
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| mycnc:change_ip_address_of_mycnc_control_board [2017/07/27 16:30] – skirillov | mycnc:change_ip_address_of_mycnc_control_board [2017/07/27 16:31] – skirillov | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| 1. Connect Host Computer with myCNC controller with USB cable. | 1. Connect Host Computer with myCNC controller with USB cable. | ||
| - | 2. Open Console window on Host Computer. If you have ARM (Odroid-C2/ | + | 2. Open Console window on Host Computer. If you have ARM (Odroid-C2/ |
| {{mycnc: | {{mycnc: | ||
| Line 13: | Line 13: | ||
| 5. If success, controller will reply with message < | 5. If success, controller will reply with message < | ||
| + | |||
| + | 6. Close Terminal Window. | ||
mycnc/change_ip_address_of_mycnc_control_board.txt · Last modified: 2024/01/25 11:51 by ivan