myCNC Online Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Change IP Address of myCNC control board ======

{{youtube>mCahGVvQ_Tw?large}}

//NOTE: Most modern myCNC control boards (past 2017) have the default IP address of 192.168.4.78.// 

 1. Connect Host Computer with myCNC controller with USB cable.

 2. Open Console window on Host Computer. If you have ARM (Odroid-C2/Raspberry/NanoPi-K2) Single Board Computer (SBC) purchased from us, click on **Terminal MATE** icon on Desktop
{{mycnc:mycnc-terminal.png}}

 3. Run "minicom" software (for ARM(Odroid-C2)/Desktop Linux)
<code>minicom -D /dev/ttyUSB0</code>
{{minicom-x.png}}

 4. Run command in terminal window to change IP address <code>#SLA 192 168 0 78</code> to change IP address to 192.168.0.78. Controller will reply <code>CMD: #SLA 192 168 0 78</code> {{minicom-x-1.png}}

 5. If success, controller will reply with message <code>IP:  192.168.000.078</code>{{minicom-x-2.png}}
 
 6. Close Terminal Window.