mycnc:closed_loop_configuration
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
mycnc:closed_loop_configuration [2018/10/09 14:07] – skirillov | mycnc:closed_loop_configuration [2019/10/21 09:53] – ivan | ||
---|---|---|---|
Line 97: | Line 97: | ||
* Write " | * Write " | ||
* Write " | * Write " | ||
- | Reading this registers has no effect and return zero value. | + | Reading this registers has no effect and return zero value. Read more about Servo ON/Servo OFF commands in this short manual: [[mycnc: |
3. Automatic Servo ON/OFF. There are 2 handler procedures in Software PLC can be used to automatic PID ON/OFF. | 3. Automatic Servo ON/OFF. There are 2 handler procedures in Software PLC can be used to automatic PID ON/OFF. |
mycnc/closed_loop_configuration.txt · Last modified: 2019/11/05 08:54 by ivan