mycnc:flatbed_correction
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:flatbed_correction [2019/06/17 12:29] – ivan | mycnc:flatbed_correction [2019/07/08 12:04] – ivan | ||
---|---|---|---|
Line 5: | Line 5: | ||
In order to account for this, go into **Settings > Config > Technology > Special Purpose > Flatbed Correction**. | In order to account for this, go into **Settings > Config > Technology > Special Purpose > Flatbed Correction**. | ||
- | The screen presented to you will look similar to the following | + | The screen presented to you will be the following: |
- | {{: | + | {{: |
- | First of all, **enable** | + | First of all, **enable** flatbed correction: |
- | {{: | + | {{: |
- | Next, the table on the settings page presents a number of values in the XY-plane and their z-positions. These values can either be inputted manually | + | Next, the table on this settings page presents a number of values in the XY-plane and their z-positions. These values can either be recorded by using the AutoMeasure procedure (recommended) or by using a sensor and recording |
- | {{: | + | Using the AutoMeasure procedure, the operator can set the reference z-height, the number of points at which the height measurements will be taken for the XY-plane, and the coordinates on which the measurements will be taken. The **Auto Measure Procedure** button can then be pressed to begin the probing process. |
+ | |||
+ | {{: | ||
+ | |||
+ | In order to use the M402 macro, move the sensor to the position you want to measure, then press the **Measure (M402) and Save** button. This will lower the sensor down until contact, then lift it back up and record the z-position at which the sensor was triggered. | ||
+ | |||
+ | {{: | ||
In order to remove any of the table level discrepancy values, you can press the Delete button for each particular value. | In order to remove any of the table level discrepancy values, you can press the Delete button for each particular value. | ||
- | {{: | + | {{: |
By adding these correction points, myCNC software will use triangulation in order to create a complete updated map of the working table. From here on, whenever Flatbed Correction is enabled, the machine will automatically adjust the z-axis height of the working tool in order to adjust for the table level changes depending on where in the XY-plane it currently is. | By adding these correction points, myCNC software will use triangulation in order to create a complete updated map of the working table. From here on, whenever Flatbed Correction is enabled, the machine will automatically adjust the z-axis height of the working tool in order to adjust for the table level changes depending on where in the XY-plane it currently is. | ||
- |
mycnc/flatbed_correction.txt · Last modified: 2022/12/01 11:37 by ivan