Differences

This shows you the differences between two versions of the page.

--- mycnc:flatbed_correction [2019/12/20 12:01] – ivan
+++ mycnc:flatbed_correction [2020/02/10 09:39] – ivan
@@ Line 9: / Line 9: @@
 {{:mycnc:flatbed-update-001-main-screen.png}}
-First of all, **enable** flatbed correction:
+The table on this settings page presents a number of values in the XY-plane and their z-positions. These values can either be recorded by using the AutoMeasure procedure (recommended) or by using a sensor and recording each point individually by using the M402 macro (older versions).
-{{:mycnc:flatbed-update-004-enabled.png}}
-Next, the table on this settings page presents a number of values in the XY-plane and their z-positions. These values can either be recorded by using the AutoMeasure procedure (recommended) or by using a sensor and recording each point individually by using the M402 macro (older versions).
 Using the AutoMeasure procedure, the operator can set the reference z-height, the number of points at which the height measurements will be taken for the XY-plane, and the coordinates on which the measurements will be taken. The **Auto Measure Procedure** button can then be pressed to begin the probing process.
@@ Line 27: / Line 23: @@
 {{:mycnc:flatbed-update-006-delete.png}}
-By adding these correction points, myCNC software will use triangulation in order to create a complete updated map of the working table. From here on, whenever Flatbed Correction is enabled, the machine will automatically adjust the z-axis height of the working tool in order to adjust for the table level changes depending on where in the XY-plane it currently is.
+By adding these correction points, myCNC software will create a updated Z-axis map of the working table. From here on, whenever Flatbed Correction is enabled, the machine will automatically adjust the z-axis height of the working tool in order to adjust for the table level changes depending on where in the XY-plane it currently is.
 ====M402 macro====