mycnc:gantry_alignment_macro_wizard
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:gantry_alignment_macro_wizard [2018/08/25 13:26] – skirillov | mycnc:gantry_alignment_macro_wizard [2018/08/26 10:45] – skirillov | ||
---|---|---|---|
Line 430: | Line 430: | ||
G91 G0 Y-1000 F500 (# Move toward Gantry Sensors) | G91 G0 Y-1000 F500 (# Move toward Gantry Sensors) | ||
- | ( It takes a time PLC controller | + | ( There is message delivery |
- | ( updated register | + | ( Need to wait some time till registers |
- | ( Add 0.5 seconds pause to get all the registers | + | ( Add 0.5 seconds pause to get all the registers |
G4 P0.5 (# Pause) | G4 P0.5 (# Pause) |
mycnc/gantry_alignment_macro_wizard.txt · Last modified: 2020/01/31 14:24 by ivan