Differences

This shows you the differences between two versions of the page.

--- mycnc:gcodes_list [2018/09/25 09:53] – skirillov
+++ mycnc:gcodes_list [2019/08/26 12:59] – ivan
@@ Line 23: / Line 23: @@
 | G20 | Unit Inches | |
 | G21 | Unit Metric | |
-| G28 | G28 Home |
+| G28 | [[mycnc:gcodes_list:g28|G28 Home]] |
 | G28.1 | Home Position Set |
 | G28.2 | Home Position #1 Save |
@@ Line 120: / Line 120: @@
 | M20 | Start Cutting | PLC | Cutting Tables |
 | M21 | Stop Cutting | PLC | Cutting Tables |
-| M23 | Thread Finishing On | PLC | Lathe |
+| M23 | [[mycnc:gcodes_list:m23_m24|Thread Finishing ON]] | PLC | Lathe |
-| M24 | Thread Finishing Off | PLC | Lathe |
+| M24 | [[mycnc:gcodes_list:m23_m24|Thread Finishing OFF]] | PLC | Lathe |
-| M30 | End Program with Rewind Pointer | Macro |  |
+| M30 | [[mycnc:gcodes_list:m30|End Program with Rewind Pointer]] | Macro |  |
 | M41 | Set Low Gears | PLC |  |
 | M41 | Set High Gears | PLC |  |
@@ Line 258: / Line 258: @@
 ==== M08 - Plasma cutting table - Drill Marking ====
-M08 is used for Drill Marking operations on Plasma Cutting machines which have drill head. Drill Marking procedure is -
+M08 is used for Drill Marking operations on Plasma Cutting machines which have drill head. Drill Marking procedure is the following:
-  * Drill Head Cylinder and Drill Powr turned ON
+  * Drill Head Cylinder and Drill Power turned ON
-  * Drill Head moves down on **Probing Speed** till **Drill probe sensor** activated
+  * Drill Head moves down on **Probing Speed** until **Drill probe sensor** activated
   * Moving speed switched to **Drill Speed** and the Head move lower to programmed **Drill Depth**
   * Drill Head moves up to **Lift Height**