mycnc:gcodes_list
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:gcodes_list [2019/08/26 12:59] – ivan | mycnc:gcodes_list [2019/09/26 09:41] – ivan | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== G-Codes list ===== | ===== G-Codes list ===== | ||
| + | |||
| + | Below is a list of G-codes currently implemented in the myCNC system. | ||
| ^ G-codes ^^^^ | ^ G-codes ^^^^ | ||
| Line 67: | Line 69: | ||
| | G64 | < | | G64 | < | ||
| | G65 | G-code macro | M | | | G65 | G-code macro | M | | ||
| - | | G68 | Rotation Coordinates Mode On | M | | ||
| - | | G69 | Rotation Coordinates Mode Off | M | | ||
| | G73 | Cycle Deep Hole Drilling | M | | | G73 | Cycle Deep Hole Drilling | M | | ||
| | G74 | Cycle Left Hand Tapping | M | | | G74 | Cycle Left Hand Tapping | M | | ||
mycnc/gcodes_list.txt · Last modified: 2023/09/29 14:15 by ivan