Differences

This shows you the differences between two versions of the page.

--- mycnc:global_variables [2019/04/04 11:42] – skirillov
+++ mycnc:global_variables [2019/04/04 11:45] – skirillov
@@ Line 362: / Line 362: @@
 | GVAR_CUTPROCESS_TIME_SOFT_OXY_START | 7604 | |
 | GVAR_CUTPROCESS_CUTSPEED | 7605 | |
-^  ^^^
+^ Oxy Fuel cutting, Automatic Gas Console ^^^
 | GVAR_CUTPROCESS_AGC_IGNITION_FUEL | 7610 | |
 | GVAR_CUTPROCESS_AGC_IGNITION_OXY_HEAT | 7611 | |
@@ Line 374: / Line 374: @@
 | GVAR_CUTPROCESS_AGC_PILOT_FUEL | 7619 | |
 | GVAR_CUTPROCESS_AGC_PILOT_OXY_HEAT | 7620 | |
+^  ^^^
 | GVAR_CUTPROCESS_GAS_SELECT1 | 7621 | |
 | GVAR_CUTPROCESS_GAS_SELECT2 | 7622 | |
+^ Plasma Cutting, Torch consumables ^^^
 | GVAR_CUTPROCESS_SHIELD_RETAINING_CAP | 7630 | |
 | GVAR_CUTPROCESS_SHIELD | 7631 | |
@@ Line 383: / Line 385: @@
 | GVAR_CUTPROCESS_ELECTRODE | 7635 | |
 | GVAR_CUTPROCESS_WATER_TUBE | 7636 | |
+^ Plasma Cutting, Height control settings ^^^
 | GVAR_CUTPROCESS_HC_PIERCE_DELAY | 7640 | |
 | GVAR_CUTPROCESS_HC_IGNITION_HEIGHT | 7641 | |
@@ Line 392: / Line 395: @@
 | GVAR_CUTPROCESS_CREEP_TIME | 7650 | |
 | GVAR_CUTPROCESS_CREEP_SPEED | 7651 | |
+^  ^^^
 | GVAR_CUTPROCESS_MIX_GAS1 | 7652 | |
 | GVAR_CUTPROCESS_MIX_GAS2 | 7653 | |
-^ Plasma Automatic Gas Console ^^^
+^ Plasma Cutting, Automatic Gas Console ^^^
 | GVAR_CUTPROCESS_AGC_PLASMA_PREFLOW | 7660 | |
 | GVAR_CUTPROCESS_AGC_SHIELD_PREFLOW | 7661 | |
 | GVAR_CUTPROCESS_AGC_PLASMA_CUTEFLOW | 7662 | |
 | GVAR_CUTPROCESS_AGC_SHIELD_CUTEFLOW | 7663 | |
-^ Plasma Manual Gas Console ^^^
+^ Plasma Cutting, Manual Gas Console ^^^
 | GVAR_CUTPROCESS_MGC_PLASMA_PREFLOW | 7670 | |
 | GVAR_CUTPROCESS_MGC_SHIELD_PREFLOW | 7671 | |
 | GVAR_CUTPROCESS_MGC_PLASMA_CUTEFLOW | 7672 | |
 | GVAR_CUTPROCESS_MGC_SHIELD_CUTEFLOW | 7673 | |
+^ Plasma Cutting ^^^
 | GVAR_CUTPROCESS_SET_PROCESS_CURRENT | 7675 | |
 | GVAR_CUTPROCESS_SET_ARC_CURRENT | 7676 | |