mycnc:global_variables
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:global_variables [2019/09/19 15:10] – ivan | mycnc:global_variables [2019/09/19 15:15] – ivan | ||
---|---|---|---|
Line 108: | Line 108: | ||
| GVAR_LATHE_GEARS | 5715 | Gear ratios can be used on lathe machines. In order to allow for constant surface speed while changing gears, the gear ratio is used. This global variable stores the value of the gear ratio to be used to calculate CSS | | | GVAR_LATHE_GEARS | 5715 | Gear ratios can be used on lathe machines. In order to allow for constant surface speed while changing gears, the gear ratio is used. This global variable stores the value of the gear ratio to be used to calculate CSS | | ||
| GVAR_MODE_SINGLE_BLOCK | 5720 | Writing " | | GVAR_MODE_SINGLE_BLOCK | 5720 | Writing " | ||
- | | GVAR_POSITION_LOG_DATA | 5730 | If Logging is stopped, writing to this register does not have an effect. If the Logging is started, writing any value to this register will add current position to the Log data array. Beside of storing into the Log Array, the Log position is stored into Global Variables | + | | GVAR_POSITION_LOG_DATA | 5730 | Height map logging. |
- | | GVAR_POSITION_LOG_CMD | 5740 | Begin/Eng Height Map Log. Writing “1” to this register will start logging. Writing “0” to this register will stop logging. All the collected | + | | GVAR_POSITION_LOG_CMD | 5740 | Begin/Eng Height Map Log. Writing “1” to this register will start logging. Writing “0” to this register will stop logging |
| GVAR_POSITION_STORED | 5900 | This register stores the flag (0 or 1) for whether the current position has been saved in flash memory. This is done every few seconds after the movement has been stopped in order to conserve the number of write operations onto flash memory. The variable flag visualization can be seen in the Diagnostics window in the bottom-right corner next to the stop button (grey for not saved - 0, red for saved - 1) | | | GVAR_POSITION_STORED | 5900 | This register stores the flag (0 or 1) for whether the current position has been saved in flash memory. This is done every few seconds after the movement has been stopped in order to conserve the number of write operations onto flash memory. The variable flag visualization can be seen in the Diagnostics window in the bottom-right corner next to the stop button (grey for not saved - 0, red for saved - 1) | | ||
| GVAR_CURRENT_MOTION_CODE | 6060 | Specifies the current motion code (useful to wait until motion has finished, for example). | | | GVAR_CURRENT_MOTION_CODE | 6060 | Specifies the current motion code (useful to wait until motion has finished, for example). | |
mycnc/global_variables.txt · Last modified: 2024/03/20 12:01 by ivan