Differences

This shows you the differences between two versions of the page.

--- mycnc:global_variables [2019/10/25 08:48] – ivan
+++ mycnc:global_variables [2020/06/16 08:49] – ivan
@@ Line 69: / Line 69: @@
 | GVAR_JOG_STEP_FLOAT | 5523 | Obsolete global variable to set a float value for the jog step using the on-screen buttons. Has since been replaced, only used on old profile versions. |
 | GVAR_SPINDLE_SPEED | 5524 | Register represents given Spindle Speed. It's equal to "Default Spindle Speed" by default. If G-code program "S"-code with new spindle speed settings executed, the value will be changed accordingly. |
-| [[mycnc:global_variables_description#5525|GVAR_SOFT_LIMITS_IGNORE]] | [[mycnc:global_variables_description#5525|5525]] | Writing "1" to this register will turn off Software Limits control temporarily. |
+| [[mycnc:global_variables_description#5525|GVAR_SOFT_LIMITS_IGNORE]] | [[mycnc:global_variables_description#5525|5525]] | Writing "1" to this register will turn off Software Limits control temporarily. Writing a value larger than 2 will initialize a timer (timer will begin after the macro is complete). |
 | GVAR_M30_SCHEDULED_REWIND | 5526 | The scheduled rewind allows the user to move back to the beginning of the program after the program run has completed. After moving back to the beginning, this variable is set to 0, so the M30 command needs to be added to the file every time the rewind is required (not on by default) |
 | GVAR_SHOW_NCMESSAGE | 5527 | Reserved for future development to be able to display a line of text from the G-code file |
@@ Line 170: / Line 170: @@
 | GVAR_MOTION_OVERSPEED | 7072 | Register represents Motion Overrate percentage.  |
 | GVAR_SPINDLE_OVERSPEED | 7073 | Register represents Spindle Overrate percentage. \\ Actual Spindle speed will be \\ Actual_Speed=Default_Speed * Spindle_Overspeed/100 \\ Default Spindle Speed defined by "Default Spindle Speed" variable and can be chaned in G-code program with S-code.  |
-| GVAR_JOG_OVERSPEED | 7074 | The jog overspeed value is directly edited through this global variable |
+| GVAR_JOG_OVERSPEED | 7074 | The jog overspeed value is directly edited through this global variable (5-150 safe range on ET6, ET7, ET10) |
 | GVAR_PROBE_SENSOR_DIAMETER | 7075 | Specifies the probe sensor diameter in mm |
 | GVAR_PROBE_SENSOR_XOFFSET | 7076 | X-axis offset for the probe sensor in millimeters |