mycnc:height_mapping
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:height_mapping [2019/10/21 15:44] – ivan | mycnc:height_mapping [2019/10/21 15:47] – ivan | ||
---|---|---|---|
Line 132: | Line 132: | ||
| | ||
};</ | };</ | ||
+ | * Note that the probe sensor number is defined in the INPUT_PROBE field. This can be changed by going into Settings > Config > PLC > Hardware PLC > pins.h, and switching the default INPUT_PROBE input number to the one used by your particular setup. After assigning a new probe number, do not forget to once again press the Save All, Build All and Send buttons to reflash the disk. | ||
+ | |||
+ | |||
====Changelog==== | ====Changelog==== | ||
mycnc/height_mapping.txt · Last modified: 2024/03/22 14:12 by ivan