Differences

This shows you the differences between two versions of the page.

--- mycnc:height_mapping [2019/10/21 15:53] – ivan
+++ mycnc:height_mapping [2019/10/21 15:56] – ivan
@@ Line 132: / Line 132: @@
    exit(99);
 };</code>
-  * Note that the probe sensor number is defined in the ''INPUT_PROBE'' field which is used in the M180 PLC procedure. This can be changed by going into ''Settings > Config > PLC > Hardware PLC > pins.h'', and switching the default <del>INPUT_PROBE</del> input number to the one used by your particular setup. After assigning a new probe number, do not forget to once again press the ''Save All'', ''Build All'' and ''Send'' buttons to reflash the disk.
+  * Note that the probe sensor number is defined in the ''INPUT_PROBE'' field which is used in the M180 PLC procedure. This can be changed by going into ''Settings > Config > PLC > Hardware PLC > pins.h'', and switching the default ''INPUT_PROBE'' input number to the one used by your particular setup. After assigning a new probe number, do not forget to once again press the ''Save All'', ''Build All'' and ''Send'' buttons to reflash the disk.