Differences

This shows you the differences between two versions of the page.

--- mycnc:height_mapping [2019/10/28 11:11] – ivan
+++ mycnc:height_mapping [2024/03/22 14:12] (current) – ivan
@@ Line 1: / Line 1: @@
 ======3D Height Mapping======
+//
+**Related articles:**//
+  * [[plc:plc_height_map|Getting a Height Map]]
+----
 <code>ATTENTION: Height mapping is currently in beta testing.</code>
@@ Line 27: / Line 32: @@
   * Press the Run button (this begins the probing process)
 {{:mycnc:height-map-2-010-run.png}}
-  * After the probing program has completed running, press the Apply Map button. The original G-code file that you have loaded in should now be corrected.
+  * After the probing program has completed running, press the Refresh button in the top ribbon.
+  * After refreshing the G-code file, press the Apply Map button. The original G-code file that you have loaded in should now be corrected.
 {{:mycnc:height-map-2-011-apply.png}}
   * After the file has been corrected for surface level imperfections, you can press the Run button again to begin the actual job.
@@ Line 37: / Line 43: @@
 {{:mycnc:height-map-2-014-settings.png}}
-====Settings up the probing procedure====
+====Setting up the probing procedure (beta users)====
 The 3D height map .xml file for the X1366M-series profiles is currently available on request (beta testing as of October 2019). In order to set up the profile once you have received the file, do the following: