User Tools

Site Tools


mycnc:i_o_expand_cards_mapping

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
mycnc:i_o_expand_cards_mapping [2018/09/21 08:13] pupalaisermycnc:i_o_expand_cards_mapping [2018/09/21 08:17] (current) pupalaiser
Line 6: Line 6:
   * Next, select the redirection conditions and the register for the mapping{{ :mycnc:expand_03.jpg?nolink |}}   * Next, select the redirection conditions and the register for the mapping{{ :mycnc:expand_03.jpg?nolink |}}
   * After selecting the register for the mapping, the input or output register of the controller, where the selected registers will be redirected. An example is presented reassignment of the register of encoder inputs of the controller ET10 as a register of the controller's common inputs port 3{{ :mycnc:expand_04_2_.jpg?nolink |}}   * After selecting the register for the mapping, the input or output register of the controller, where the selected registers will be redirected. An example is presented reassignment of the register of encoder inputs of the controller ET10 as a register of the controller's common inputs port 3{{ :mycnc:expand_04_2_.jpg?nolink |}}
-  * This example shows how to connect an external controller to the modbus interface. At the remote controller with id = 1 input port number 2 (inputs from 32 to 47) is pushed to the input virtual port of controller number 3 (inputs from 48 to 63){{ :mycnc:expand_05.jpg?nolink |}}+  * This example shows how to connect an external controller to the modbus interface. At the remote controller with id = 1 input port number 2 (inputs from 32 to 47) is pushed to the input virtual port of controller number 3 (inputs from 48 to 63). The LED layouts below show the state of the port for each of the inputs.{{ :mycnc:expand_05.jpg?nolink |}} 
 +  * Similarly, mapping is also established on output registers.At the remote controller with id = 1 output port number 2 (outputs from 32 to 47) is pushed to the output virtual port of controller number 3 (outputs from 48 to 63). The LED layouts below show the state of the port for each of the outputs).{{ :mycnc:expand_06.jpg?nolink |}}
  
mycnc/i_o_expand_cards_mapping.txt · Last modified: 2018/09/21 08:17 by pupalaiser

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki