mycnc:ihc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:ihc [2019/11/07 09:33] – ivan | mycnc:ihc [2019/11/07 10:36] – ivan | ||
---|---|---|---|
Line 42: | Line 42: | ||
{{: | {{: | ||
- | If, for example, a pneumatic probe system has been used, the IHC Ignition Height is equal to 5, and the IHC Correction Height is equal to -1, the system will go up by 4 mm after contact with the working surface has been made. | + | If, for example, a pneumatic probe system has been used, the IHC Ignition Height is equal to 6.0, and the IHC Correction Height is equal to 1.0, the system will go up by 7.0 mm after contact with the working surface has been made. |
====IHC and Arc Sensors==== | ====IHC and Arc Sensors==== |
mycnc/ihc.txt · Last modified: 2021/04/29 09:54 by ivan