mycnc:independent_pulse_generator
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:independent_pulse_generator [2018/09/02 11:03] – skirillov | mycnc:independent_pulse_generator [2018/09/02 14:06] – skirillov | ||
---|---|---|---|
Line 6: | Line 6: | ||
< | < | ||
Independent Pulse Generator was added to firmware dated July 20, 2018. | Independent Pulse Generator was added to firmware dated July 20, 2018. | ||
- | At the moment the firmware is available as the " | + | At the moment the firmware is available as the |
+ | " | ||
</ | </ | ||
Line 16: | Line 17: | ||
^ Register Name ^ Address ^ Description ^ | ^ Register Name ^ Address ^ Description ^ | ||
- | | GVAR_GENERATOR_FRQ_RAW | 8130 | Pulse Generator RAW frequency value, [units] \\ 1 unit = | | + | | GVAR_GENERATOR_FRQ_RAW | 8130 | Pulse Generator RAW frequency value, [units] \\ 1 unit = 0.000736 Hz | |
| GVAR_GENERATOR_ACCEL | 8131 | Generator Acceleration, | | GVAR_GENERATOR_ACCEL | 8131 | Generator Acceleration, | ||
| GVAR_GENERATOR_FRQ_RATIO | 8132 | Generator Frequency Ratio | | | GVAR_GENERATOR_FRQ_RATIO | 8132 | Generator Frequency Ratio | | ||
Line 110: | Line 111: | ||
* the Ratio set up | * the Ratio set up | ||
- | It's supposed operator no need to change frequency acceleration and this setting is hidden from operator. | + | It's supposed operator no need to change frequency acceleration and this setting is hidden from an |
The acceleration can be set up in the Software or Hardware PLC for example. | The acceleration can be set up in the Software or Hardware PLC for example. | ||
mycnc/independent_pulse_generator.txt · Last modified: 2022/02/11 15:45 by ivan