mycnc:independent_pulse_generator
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| mycnc:independent_pulse_generator [2018/09/02 11:04] – skirillov | mycnc:independent_pulse_generator [2018/09/02 14:06] – skirillov | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| < | < | ||
| Independent Pulse Generator was added to firmware dated July 20, 2018. | Independent Pulse Generator was added to firmware dated July 20, 2018. | ||
| - | At the moment the firmware is available as | + | At the moment the firmware is available as the |
| - | the " | + | " |
| </ | </ | ||
| Line 17: | Line 17: | ||
| ^ Register Name ^ Address ^ Description ^ | ^ Register Name ^ Address ^ Description ^ | ||
| - | | GVAR_GENERATOR_FRQ_RAW | 8130 | Pulse Generator RAW frequency value, [units] \\ 1 unit = | | + | | GVAR_GENERATOR_FRQ_RAW | 8130 | Pulse Generator RAW frequency value, [units] \\ 1 unit = 0.000736 Hz | |
| | GVAR_GENERATOR_ACCEL | 8131 | Generator Acceleration, | | GVAR_GENERATOR_ACCEL | 8131 | Generator Acceleration, | ||
| | GVAR_GENERATOR_FRQ_RATIO | 8132 | Generator Frequency Ratio | | | GVAR_GENERATOR_FRQ_RATIO | 8132 | Generator Frequency Ratio | | ||
| Line 111: | Line 111: | ||
| * the Ratio set up | * the Ratio set up | ||
| - | It's supposed operator no need to change frequency acceleration and this setting is hidden from operator. | + | It's supposed operator no need to change frequency acceleration and this setting is hidden from an |
| The acceleration can be set up in the Software or Hardware PLC for example. | The acceleration can be set up in the Software or Hardware PLC for example. | ||
mycnc/independent_pulse_generator.txt · Last modified: 2022/02/11 15:45 by ivan