mycnc:independent_pulse_generator
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:independent_pulse_generator [2018/09/02 11:05] – skirillov | mycnc:independent_pulse_generator [2018/09/02 14:06] – skirillov | ||
---|---|---|---|
Line 7: | Line 7: | ||
Independent Pulse Generator was added to firmware dated July 20, 2018. | Independent Pulse Generator was added to firmware dated July 20, 2018. | ||
At the moment the firmware is available as the | At the moment the firmware is available as the | ||
- | " | + | " |
</ | </ | ||
Line 17: | Line 17: | ||
^ Register Name ^ Address ^ Description ^ | ^ Register Name ^ Address ^ Description ^ | ||
- | | GVAR_GENERATOR_FRQ_RAW | 8130 | Pulse Generator RAW frequency value, [units] \\ 1 unit = | | + | | GVAR_GENERATOR_FRQ_RAW | 8130 | Pulse Generator RAW frequency value, [units] \\ 1 unit = 0.000736 Hz | |
| GVAR_GENERATOR_ACCEL | 8131 | Generator Acceleration, | | GVAR_GENERATOR_ACCEL | 8131 | Generator Acceleration, | ||
| GVAR_GENERATOR_FRQ_RATIO | 8132 | Generator Frequency Ratio | | | GVAR_GENERATOR_FRQ_RATIO | 8132 | Generator Frequency Ratio | |
mycnc/independent_pulse_generator.txt · Last modified: 2022/02/11 15:45 by ivan