mycnc:limits
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:limits [2018/08/14 10:05] – pupalaiser | mycnc:limits [2018/08/14 10:08] – pupalaiser | ||
---|---|---|---|
Line 26: | Line 26: | ||
* Function "Jog slow down" - when this function is activated, the machine during the movement will reduce the speed at the entrance to the above specified software limits. The distance at which the speed decreases and the percentage reduction in speed is set in the corresponding table. | * Function "Jog slow down" - when this function is activated, the machine during the movement will reduce the speed at the entrance to the above specified software limits. The distance at which the speed decreases and the percentage reduction in speed is set in the corresponding table. | ||
- | * To activate the function "Soft Limits Enabled" , it is necessary to check the box next to its name:{{ : | + | * To activate the function "Jog slow down" , it is necessary to check the box next to its name:{{ : |
- | * {{ : | + | * The example below shows the setting of the function for several axes (X, Y, Z, A, B){{ : |
mycnc/limits.txt · Last modified: 2018/08/16 04:50 by pupalaiser