mycnc:limits
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
mycnc:limits [2018/08/14 10:05] – pupalaiser | mycnc:limits [2018/08/16 04:50] – pupalaiser | ||
---|---|---|---|
Line 26: | Line 26: | ||
* Function "Jog slow down" - when this function is activated, the machine during the movement will reduce the speed at the entrance to the above specified software limits. The distance at which the speed decreases and the percentage reduction in speed is set in the corresponding table. | * Function "Jog slow down" - when this function is activated, the machine during the movement will reduce the speed at the entrance to the above specified software limits. The distance at which the speed decreases and the percentage reduction in speed is set in the corresponding table. | ||
- | * To activate the function "Soft Limits Enabled" , it is necessary to check the box next to its name:{{ : | + | * To activate the function "Jog slow down" , it is necessary to check the box next to its name:{{ : |
- | * {{ : | + | * The example below shows the setting of the function for several axes (X, Y, Z, A, B){{ : |
+ | * Taking into account the settings of software limits and settings of the function, the machine will move with a speed reduced to 20% in the coordinates from 0 to 50 (0 + 50) and from 2960 to 3010 (2960 + 50 = 3010). Similarly, when moving along the coordinate Y in coordinates from 0 to 50 (0 + 50) and from 1460 to 1510 (1460 + 50 = 1510) it will move with a speed reduced to 20%. | ||
+ | In the same way, when moving along the coordinate Z, in the coordinates from -300 to -280 (-300 + 20 = -280) and from -20 to 0 (0-20 = -20) it will move with a speed reduced to 20%.{{ : | ||
mycnc/limits.txt · Last modified: 2018/08/16 04:50 by pupalaiser