mycnc:linear_encoder_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:linear_encoder_setup [2019/12/05 12:53] – ivan | mycnc:linear_encoder_setup [2019/12/05 13:07] – ivan | ||
---|---|---|---|
Line 3: | Line 3: | ||
//Read more about the topic in the [[mycnc: | //Read more about the topic in the [[mycnc: | ||
- | Linear encoders are typically used on higher-end machines to allow for a more precise monitoring of the difference between the real and the expected machine position. This article focuses on the linear encoder setup and on the methods to make the information obtained from the encoders useful within the myCNC software. | + | Linear encoders are typically used on higher-end machines to allow for a more precise monitoring of the difference between the real and the expected machine position |
The following window is available upon navigating to Settings > Config > Hardware > Encoders: | The following window is available upon navigating to Settings > Config > Hardware > Encoders: |
mycnc/linear_encoder_setup.txt · Last modified: 2021/03/11 15:06 by ivan