mycnc:m6_tool_change_macro:m6_tool_change_macro
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
mycnc:m6_tool_change_macro:m6_tool_change_macro [2019/11/15 10:19] – ivan | mycnc:m6_tool_change_macro:m6_tool_change_macro [2023/09/29 11:23] – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== M6 Tool Change Macro ===== | ===== M6 Tool Change Macro ===== | ||
+ | |||
+ | **NOTE:** For the M6TXX codes to work, they must be enabled in the myCNC Settings (Settings > Config > G-codes settings): | ||
+ | |||
+ | {{:: | ||
T-code of G-codes has higher priority than M6. For a command < | T-code of G-codes has higher priority than M6. For a command < | ||
Line 131: | Line 135: | ||
Note that if it is necessary to prevent z-axis movement at the beginning of the program, it is also required to set the Lift Height to 0 during the DXF import (this is typically not recommended for safety reasons). | Note that if it is necessary to prevent z-axis movement at the beginning of the program, it is also required to set the Lift Height to 0 during the DXF import (this is typically not recommended for safety reasons). | ||
+ | |||
+ | ==== Notes ==== | ||
+ | |||
+ | === G53 === | ||
+ | |||
+ | In system macros (especially in which coordinates are reassigned and/or reset), G0 positioning codes **must** be used. | ||
mycnc/m6_tool_change_macro/m6_tool_change_macro.txt · Last modified: 2023/09/29 14:16 by ivan