mycnc:m6_tool_change_macro:m6_tool_change_macro
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:m6_tool_change_macro:m6_tool_change_macro [2019/10/15 12:09] – ivan | mycnc:m6_tool_change_macro:m6_tool_change_macro [2019/11/15 10:19] – ivan | ||
---|---|---|---|
Line 3: | Line 3: | ||
T-code of G-codes has higher priority than M6. For a command < | T-code of G-codes has higher priority than M6. For a command < | ||
- | T1 ... T99 are defined as macros in myCNC software. T-macro normally contains | + | T1 ... T99 are defined as macros in myCNC software. T-macro normally contains |
Examples - | Examples - | ||
<code C T1>G10 L80 P5409 Q1</ | <code C T1>G10 L80 P5409 Q1</ |
mycnc/m6_tool_change_macro/m6_tool_change_macro.txt · Last modified: 2023/09/29 14:16 by ivan