mycnc:m6_tool_change_macro:m6_tool_change_macro
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:m6_tool_change_macro:m6_tool_change_macro [2019/10/15 12:09] – ivan | mycnc:m6_tool_change_macro:m6_tool_change_macro [2020/05/18 11:06] – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== M6 Tool Change Macro ===== | ===== M6 Tool Change Macro ===== | ||
+ | |||
+ | **NOTE:** For the M6TXX codes to work, they must be enabled in the myCNC Settings (Settings > Config > G-codes settings): | ||
+ | |||
+ | {{:: | ||
T-code of G-codes has higher priority than M6. For a command < | T-code of G-codes has higher priority than M6. For a command < | ||
- | T1 ... T99 are defined as macros in myCNC software. T-macro normally contains | + | T1 ... T99 are defined as macros in myCNC software. T-macro normally contains |
Examples - | Examples - | ||
<code C T1>G10 L80 P5409 Q1</ | <code C T1>G10 L80 P5409 Q1</ |
mycnc/m6_tool_change_macro/m6_tool_change_macro.txt · Last modified: 2023/09/29 14:16 by ivan