mycnc:m6_tool_change_macro:m6_tool_change_macro
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:m6_tool_change_macro:m6_tool_change_macro [2020/05/18 11:06] – ivan | mycnc:m6_tool_change_macro:m6_tool_change_macro [2022/03/29 16:16] – ivan | ||
---|---|---|---|
Line 135: | Line 135: | ||
Note that if it is necessary to prevent z-axis movement at the beginning of the program, it is also required to set the Lift Height to 0 during the DXF import (this is typically not recommended for safety reasons). | Note that if it is necessary to prevent z-axis movement at the beginning of the program, it is also required to set the Lift Height to 0 during the DXF import (this is typically not recommended for safety reasons). | ||
+ | |||
+ | // | ||
+ | Quick additional note: in system macros (especially in which coordinates are reassigned and/or reset), G0 positioning codes must be used.// | ||
mycnc/m6_tool_change_macro/m6_tool_change_macro.txt · Last modified: 2023/09/29 14:16 by ivan