mycnc:m6_tool_change_macro:m6_tool_change_macro
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| mycnc:m6_tool_change_macro:m6_tool_change_macro [2020/05/18 11:06] – ivan | mycnc:m6_tool_change_macro:m6_tool_change_macro [2023/09/29 14:16] (current) – ivan | ||
|---|---|---|---|
| Line 135: | Line 135: | ||
| Note that if it is necessary to prevent z-axis movement at the beginning of the program, it is also required to set the Lift Height to 0 during the DXF import (this is typically not recommended for safety reasons). | Note that if it is necessary to prevent z-axis movement at the beginning of the program, it is also required to set the Lift Height to 0 during the DXF import (this is typically not recommended for safety reasons). | ||
| + | |||
| + | ==== Notes ==== | ||
| + | |||
| + | === G53 === | ||
| + | |||
| + | In system macros (especially in which coordinates are reassigned and/or reset), G0 positioning codes **must** be used. See [[mycnc: | ||
mycnc/m6_tool_change_macro/m6_tool_change_macro.1589814416.txt.gz · Last modified: 2020/05/18 11:06 by ivan