Differences

This shows you the differences between two versions of the page.

--- mycnc:move-a-to-0 [2017/09/04 12:06] – created skirillov
+++ mycnc:move-a-to-0 [2017/09/04 12:09] – skirillov
@@ Line 2: / Line 2: @@
 For some applications A-axis is programmed as endless rotation.
-Program position of A may come to many hyndreds degree after G-code finished. See screenshot example below -
+Program **A** position may come to many thousands degree after G-code finished. See screenshot example below -
 {{mycnc:mycnc-1280m4-001.png}}
-To start new job A position should be roll back to about "0" position. Jogging to "0" may take a long time. In some cases it's possible just reset A position, but A axis orientation will be lost.
+To start new job A position should be roll back to about "0" position. Jogging to "0" may take a long time (can be hundreds of complete turn to run). In some cases it's possible just reset A position, but A axis orientation will be lost.
-The best way to substract from current A-coordinates a whole number of turns (360 degree), then move to "0".
+The best way to subtract a number of complete turns (360 degree), then move to "0" for the rest of A.
 This can be done through macro-programming.