mycnc:move-a-to-0
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:move-a-to-0 [2017/09/04 12:06] – created skirillov | mycnc:move-a-to-0 [2017/09/04 12:11] – skirillov | ||
---|---|---|---|
Line 2: | Line 2: | ||
For some applications A-axis is programmed as endless rotation. | For some applications A-axis is programmed as endless rotation. | ||
- | Program | + | Program |
{{mycnc: | {{mycnc: | ||
- | To start new job A position should be roll back to about " | + | To start new job A position should be roll back to about " |
- | The best way to substract from current A-coordinates | + | The best way to subtract |
This can be done through macro-programming. | This can be done through macro-programming. | ||
Line 45: | Line 45: | ||
</ | </ | ||
- | [[mycnc:mycnc_setup# | + | [[mycnc:mycnc_screen_configuration# |
mycnc/move-a-to-0.txt · Last modified: 2019/11/18 11:37 by ivan