User Tools

Site Tools


mycnc:mpg_through_binary_inputs

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
mycnc:mpg_through_binary_inputs [2019/08/22 11:58] ivanmycnc:mpg_through_binary_inputs [2019/08/23 09:49] ivan
Line 61: Line 61:
 The following diagram shows an example of an MPG wheel connection to the ET10 controller (encoder #5): The following diagram shows an example of an MPG wheel connection to the ET10 controller (encoder #5):
  
-{{:mycnc:et10-connection-encoders-mpg-001.png}}+{{:mycnc:et10-connection-encoders-mpg-002.png}}
  
-In order to set up this encoder to change some values within the software (such as jog overspeed, motion overspeed, etc), the user can go into Settings > Config > Inputs/Outputs/Sensors > Connections, and add a new connection or edit an existing one.+In order to set up this encoder to change some values within the software (such as jog overspeed, motion overspeed, etc) or to jog axes, the user can go into Settings > Config > Inputs/Outputs/Sensors > Connections, and add a new connection or edit an existing one.
   * In the **Source** field, select Encoder.    * In the **Source** field, select Encoder. 
   * For the **parameter**, type in some parameter 100-112 for fast encoders (0-16 is reserved for slow encoders). In order to check which particular encoder is used, the user can go into Settings > Config > Hardware > Encoders and note which encoder value changes as the MPG wheel is being turned. For example, for fast encoder #5, parameter 105 will be chosen.    * For the **parameter**, type in some parameter 100-112 for fast encoders (0-16 is reserved for slow encoders). In order to check which particular encoder is used, the user can go into Settings > Config > Hardware > Encoders and note which encoder value changes as the MPG wheel is being turned. For example, for fast encoder #5, parameter 105 will be chosen. 
mycnc/mpg_through_binary_inputs.txt · Last modified: 2019/12/30 11:41 by ivan

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki