Differences

This shows you the differences between two versions of the page.

--- mycnc:mpg_through_binary_inputs [2019/11/11 09:29] – ivan
+++ mycnc:mpg_through_binary_inputs [2019/11/11 09:34] – ivan
@@ Line 64: / Line 64: @@
 {{:mycnc:et10-connection-encoders-mpg-002.png}}
-In order to set up this encoder to change some values within the software (such as jog overspeed, motion overspeed, etc) or to jog axes, the user can go into Settings > Config > Inputs/Outputs/Sensors > Connections, and add a new connection or edit an existing one.
+As already mentioned, axis control can be set up directly from the //MPG through binary inputs// settings window. In order to set up this encoder to change some values within the software (such as jog overspeed, motion overspeed, etc), the user can go into Settings > Config > Inputs/Outputs/Sensors > Connections, and add a new connection or edit an existing one.
   * In the **Source** field, select Encoder.
   * For the **parameter**, type in some parameter 100-112 for fast encoders (0-16 is reserved for slow encoders). In order to check which particular encoder is used, the user can go into Settings > Config > Hardware > Encoders and note which encoder value changes as the MPG wheel is being turned. For example, for fast encoder #5, parameter 105 will be chosen.
@@ Line 74: / Line 74: @@
 {{:mycnc:mpg-encoder-setup-002.png}}
-This will allow us to use the MPG wheel connected to the encoder inputs to change a number of myCNC parameters.
+This will allow us to use the MPG wheel connected to the encoder inputs to change a number of myCNC parameters of the fly.