mycnc:mycnc_advantages
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:mycnc_advantages [2020/07/31 10:39] – ivan | mycnc:mycnc_advantages [2020/07/31 11:06] – ivan | ||
---|---|---|---|
Line 40: | Line 40: | ||
In comparison with the " | In comparison with the " | ||
{{: | {{: | ||
+ | |||
+ | ===Hole Cutting=== | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | A 2D (or a 2.5D) file such as the one shown above contains both the outer and the inner contours of the part being cut. In certain applications (plasma cutting, tangential knife cutting) it is preferable to have a separate (often lower) speed for the holes that are located inside the main contour. However, a number of CAM programs do not accommodate for this need if they do not have an implementation for two separate speeds. | ||
+ | |||
+ | To solve this issue, myCNC features an Arcs Slow Speed Control settings (Settings > Motion) which allows the user to quickly set up hole cutting speed based on the arc diameter of the hole in question: | ||
+ | |||
+ | {{: | ||
===Detail Multiplication=== | ===Detail Multiplication=== |
mycnc/mycnc_advantages.txt · Last modified: 2021/01/14 16:03 by ivan