Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_advantages [2019/05/14 12:58] – ivan
+++ mycnc:mycnc_advantages [2019/05/14 13:19] – ivan
@@ Line 58: / Line 58: @@
 ===Cutting from the edge of the sheet===
-In case the cutting is done on a thick sheet, it can be hard to perform the initial cut in order to break through the material for the first time. In this case, the edge cutting function can be used, since the breakthrough process is a lot less demanding if performed on the edge of the sheet. In this mode, a spot for the cut will be selected, the part itself is selected through scrolling to the necessary cutting command (as shown above), after which the operator can move the machine from the cutting position to the closest point at the edge of the material sheet and turn on the edge cutting mode.
+In case the cutting is done on a thick sheet, it can be hard to perform the initial cut in order to punch through the material for the first time. In this case, the edge cutting function can be used, since the breakthrough process is a lot less demanding if performed on the edge of the sheet. In this mode, a spot for the cut will be selected, the part itself is selected through scrolling to the necessary cutting command (as shown above), after which the operator can move the machine from the cutting position to the closest point at the edge of the material sheet and turn on the edge cutting mode.
-This will automatically start the initial contact and ignition procedure, after which the machine will automatically move directly to its actual cutting position upon reaching which it will continue to execute the cutting program.
+This will automatically start the initial contact and ignition procedure, after which the machine will move directly to its actual cutting position upon reaching which it will continue to execute the cutting program.
 ===Parts Library===
@@ Line 86: / Line 86: @@
 The results of the system working with such an imported DXF file, library parts, or part multiplication are saved as G-code files. Therefore, the myCNC software can be used with third-party CNC control systems to prepare the necessary G-code commands.
+===Cut Charts===
+myCNC software makes it possible to create cut charts for different types of plasma cutting sources. The list of parameters that the operator indicates when loading a module from a table can be configured. Usually the following parameters are considered:
+  * material (regular steel, stainless steel, aluminum, titanium, etc)
+  * thickness
+  * cutting current
+When loading the control system, the following parameters will be loaded from the cut charts (provided they have been inputted)
+  * cutting speed
+  * ignition height
+  * punching height
+  * punching time
+  * cutting height (arc reference voltage for THC)
+  * Cutting current
+  * The magnitude of current decrease at the trajectory corners
+  * Cut width adjustment (Kerf)
+  * Crawling speed (during punching through)
+  * Driving time at creeping speed (when punching)
+  * The delay time to enable tracking after punching
+  * Gas parameters for manual and automatic Hypertherm console (type of cutting and shielding gases, MixGas1, MixGas2 gas mix values, plasma torch cutting and shielding channel pressure values during Preflow and Cut)
+  * Consumable components of the plasma torch as auxiliary information for the operator of the machine (types of electrodes, nozzle, protective nozzle, protective cap, swirl and water tube)