mycnc:mycnc_advantages
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| mycnc:mycnc_advantages [2020/07/31 11:06] – ivan | mycnc:mycnc_advantages [2020/07/31 11:06] – ivan | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| This article goes over a number of such advantages and opportunities that are present in myCNC software compared to the other major CNC control systems. | This article goes over a number of such advantages and opportunities that are present in myCNC software compared to the other major CNC control systems. | ||
| - | |||
| - | |||
| - | ====Plasma and Oxy-fuel Cutting==== | ||
| ===Stopping and resuming the program=== | ===Stopping and resuming the program=== | ||
| Line 44: | Line 41: | ||
| {{: | {{: | ||
| - | {{: | ||
| A 2D (or a 2.5D) file such as the one shown above contains both the outer and the inner contours of the part being cut. In certain applications (plasma cutting, tangential knife cutting) it is preferable to have a separate (often lower) speed for the holes that are located inside the main contour. However, a number of CAM programs do not accommodate for this need if they do not have an implementation for two separate speeds. | A 2D (or a 2.5D) file such as the one shown above contains both the outer and the inner contours of the part being cut. In certain applications (plasma cutting, tangential knife cutting) it is preferable to have a separate (often lower) speed for the holes that are located inside the main contour. However, a number of CAM programs do not accommodate for this need if they do not have an implementation for two separate speeds. | ||
mycnc/mycnc_advantages.txt · Last modified: 2021/01/14 16:03 by ivan