mycnc:mycnc_advantages
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| mycnc:mycnc_advantages [2020/07/31 11:06] – ivan | mycnc:mycnc_advantages [2020/09/14 14:43] – ivan | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| This article goes over a number of such advantages and opportunities that are present in myCNC software compared to the other major CNC control systems. | This article goes over a number of such advantages and opportunities that are present in myCNC software compared to the other major CNC control systems. | ||
| - | |||
| - | |||
| - | ====Plasma and Oxy-fuel Cutting==== | ||
| ===Stopping and resuming the program=== | ===Stopping and resuming the program=== | ||
| Line 44: | Line 41: | ||
| {{: | {{: | ||
| - | {{: | ||
| - | A 2D (or a 2.5D) file such as the one shown above contains both the outer and the inner contours of the part being cut. In certain applications (plasma cutting, tangential knife cutting) it is preferable to have a separate (often lower) speed for the holes that are located inside the main contour. However, a number of CAM programs do not accommodate for this need if they do not have an implementation for two separate speeds. | + | A 2D (or a 2.5D) file such as the one shown above contains both the outer and the inner contours of the part being cut. In certain applications (such as plasma cutting, tangential knife cutting) it is preferable to have a separate (often lower) speed for the holes that are located inside the main contour. However, a number of CAM programs do not accommodate for this need if they do not have an implementation for two separate speeds. |
| To solve this issue, myCNC features an Arcs Slow Speed Control settings (Settings > Motion) which allows the user to quickly set up hole cutting speed based on the arc diameter of the hole in question: | To solve this issue, myCNC features an Arcs Slow Speed Control settings (Settings > Motion) which allows the user to quickly set up hole cutting speed based on the arc diameter of the hole in question: | ||
| Line 100: | Line 96: | ||
| ===Cut Charts=== | ===Cut Charts=== | ||
| + | |||
| + | {{youtube> | ||
| + | |||
| myCNC software makes it possible to create cut charts for different types of plasma cutting sources. The list of parameters that the operator indicates when loading a module from a table can be configured. Usually the following parameters are considered: | myCNC software makes it possible to create cut charts for different types of plasma cutting sources. The list of parameters that the operator indicates when loading a module from a table can be configured. Usually the following parameters are considered: | ||
| * material (regular steel, stainless steel, aluminum, titanium, etc) | * material (regular steel, stainless steel, aluminum, titanium, etc) | ||
mycnc/mycnc_advantages.txt · Last modified: 2021/01/14 16:03 by ivan