mycnc:mycnc_configuration_dialogs
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mycnc_configuration_dialogs [2019/07/12 15:49] – ivan | mycnc:mycnc_configuration_dialogs [2019/07/15 09:34] – ivan | ||
|---|---|---|---|
| Line 132: | Line 132: | ||
| * Slot can be changed between MPG (to move the spindle around), THC/Z axis offset for manual control of the z-axis during torch height control, or Spindle Sync to synchronize the vertical z-axis movement and the rotation of the spindle. | * Slot can be changed between MPG (to move the spindle around), THC/Z axis offset for manual control of the z-axis during torch height control, or Spindle Sync to synchronize the vertical z-axis movement and the rotation of the spindle. | ||
| * Encoder resolution: number of encoder markings per rotation * number of impulses per marking | * Encoder resolution: number of encoder markings per rotation * number of impulses per marking | ||
| + | |||
| + | As the ET10 controller has dedicated input ports for manual pulse generators, it is not needed to specify 2 different ports but rather one dedicated encoder port number for an ET10 setup. | ||
| === Jog through ADC inputs === | === Jog through ADC inputs === | ||
mycnc/mycnc_configuration_dialogs.txt · Last modified: 2022/10/28 15:51 by ivan