mycnc:mycnc_configuration_dialogs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_configuration_dialogs [2019/07/15 09:34] – ivan | mycnc:mycnc_configuration_dialogs [2019/07/15 11:23] – ivan | ||
---|---|---|---|
Line 188: | Line 188: | ||
===Connections=== | ===Connections=== | ||
{{: | {{: | ||
+ | The connections tab outlines: | ||
+ | * the connection source (ADC, DAC, PWM, Input Pin, Input Port, Output Pin, Output Port, Encoder, Global variable, Item, XItem) | ||
+ | * source parameter | ||
+ | * connection destination | ||
+ | * destination parameter | ||
+ | * K values (ratio values) K and K0 | ||
====Network==== | ====Network==== | ||
Line 208: | Line 214: | ||
====Motion==== | ====Motion==== | ||
- | |||
Upon opening the Motion tab in Settings, you are presented with the following window: | Upon opening the Motion tab in Settings, you are presented with the following window: | ||
Line 232: | Line 237: | ||
===Hardware PLC=== | ===Hardware PLC=== | ||
{{: | {{: | ||
- | + | This list presents the available hardware PLC macros, with the ability to add, delete and edit the individual macros as required. After editing the hardware PLC, remember to press the Build All, Save All and Send buttons for the changes to take effect. | |
- | This list presents the available hardware PLC macros, with the ability to add, delete and edit the individual macros as required. | + | |
===Hardware PLC Templates=== | ===Hardware PLC Templates=== | ||
Line 352: | Line 356: | ||
* **Lib storage folder** specifies the folder in which the library parts are stored on the computer. | * **Lib storage folder** specifies the folder in which the library parts are stored on the computer. | ||
* **NC code filename extensions** list the possible extensions that the software will allow the user to open. If an extension is not on the list, it can be added provided it can be read by the myCNC software. | * **NC code filename extensions** list the possible extensions that the software will allow the user to open. If an extension is not on the list, it can be added provided it can be read by the myCNC software. | ||
- | * **G04 cycle time** marks the internal controller setting for time marking in order to properly synchronize the controller and the computer. | + | * **G04 cycle time** marks the internal controller setting for time marking in order to properly synchronize the controller and the computer. |
* The **Disable keyboard Events** setting allows to completely disable keyboard inputs, leaving only the touchscreen. | * The **Disable keyboard Events** setting allows to completely disable keyboard inputs, leaving only the touchscreen. | ||
* The basic machine profile can be specified to be Mill/ | * The basic machine profile can be specified to be Mill/ | ||
Line 370: | Line 374: | ||
{{: | {{: | ||
- | Consult the QuickStart [[quickstart: | + | The Start/Stop settings specify the behaviour of the machine as the start/stop commands are sent to it. Consult the QuickStart [[quickstart: |
===Shape Library Settings=== | ===Shape Library Settings=== |
mycnc/mycnc_configuration_dialogs.txt · Last modified: 2022/10/28 15:51 by ivan