Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_configuration_dialogs [2019/08/19 12:03] – ivan
+++ mycnc:mycnc_configuration_dialogs [2019/08/22 12:44] – ivan
@@ Line 135: / Line 135: @@
 NOTE: The ET7 controller has the two encoder slots reserved for the ET7 keyboard panel. These are permanently assigned to inputs #16, #17, #18, and #19, and changes in the Config window will not override this preset. If encoder slots are to be used on an ET7 board, the latter two are recommended. This setting is not present on the ET6/ET10/ET15 boards, where encoders 0-3 can be all used.
+NOTE #2: The ET10 controller can utilize inputs 0-31 for its binary inputs for an encoder setup. IN32-39 are reserved and are not suited for binary input configurations with an MPG wheel etc.
+The full MPG though binary inputs manual is available [[mycnc:mpg_through_binary_inputs|here]].
 {{:mycnc:config-062-mpg-et7.png}}
@@ Line 908: / Line 912: @@
 ===Gamepad===
-{{:mycnc:config-042-gamepad.png}}
+{{:mycnc:config-071-gamepad-updated.png}}
 Allows the user to take control of the machine through a joystick/gamepad controller.
+After connecting a gamepad to the host computer, the following options are available:
+  * Enable/disable toggle for gamepad control
+  * Joystick/gamepad selection field.
+  * Joystick settings. It is possible to assign both axes (up/down and left/right) of the controller joysticks to a movement in the negative/positive XYZ axis for the machine. The directions can also be flipped by scrolling through the movement options (such as left = positive X and right = negative X, or vice versa).
+  * Each of the controller keys can be defined to perform some action when pressed. The full list of the possible actions can be found in the [[mycnc:wireless_pendants|Wireless Pendants]] manual.
+  * Hat #0-9 can also be assigned some actions. Hat 0 specifies the default position of the arrow keys (with no keys pressed), and can also be assigned some action or command (for example, to trigger when one of the arrow keys is released).
 Another option for joystick control can be found in the [[mycnc:jog_through_adc_inputs|Jog through ADC inputs]] section of myCNC settings.