mycnc:mycnc_configuration_dialogs
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mycnc_configuration_dialogs [2019/08/22 12:10] – ivan | mycnc:mycnc_configuration_dialogs [2019/08/22 12:44] – ivan | ||
|---|---|---|---|
| Line 135: | Line 135: | ||
| NOTE: The ET7 controller has the two encoder slots reserved for the ET7 keyboard panel. These are permanently assigned to inputs #16, #17, #18, and #19, and changes in the Config window will not override this preset. If encoder slots are to be used on an ET7 board, the latter two are recommended. This setting is not present on the ET6/ | NOTE: The ET7 controller has the two encoder slots reserved for the ET7 keyboard panel. These are permanently assigned to inputs #16, #17, #18, and #19, and changes in the Config window will not override this preset. If encoder slots are to be used on an ET7 board, the latter two are recommended. This setting is not present on the ET6/ | ||
| + | |||
| + | NOTE #2: The ET10 controller can utilize inputs 0-31 for its binary inputs for an encoder setup. IN32-39 are reserved and are not suited for binary input configurations with an MPG wheel etc. | ||
| The full MPG though binary inputs manual is available [[mycnc: | The full MPG though binary inputs manual is available [[mycnc: | ||
mycnc/mycnc_configuration_dialogs.txt · Last modified: 2022/10/28 15:51 by ivan