mycnc:mycnc_configuration_dialogs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:mycnc_configuration_dialogs [2019/08/22 12:44] – ivan | mycnc:mycnc_configuration_dialogs [2019/08/23 11:26] – ivan | ||
---|---|---|---|
Line 929: | Line 929: | ||
{{: | {{: | ||
- | The Hotkeys settings window describes the possible hotkeys which are present in the software. | + | The Hotkeys settings window describes the possible hotkeys which are present in the software. These keys allow the user to control the machine directly from the keyboard, by using some commands which the user can assign to different actions. |
By default, the Shift and Control key are used to set different values of the Jog Overspeed %, allowing the user to quickly control jog speed with a single press. These can be set to be at different percentages (10 and 100 by default). | By default, the Shift and Control key are used to set different values of the Jog Overspeed %, allowing the user to quickly control jog speed with a single press. These can be set to be at different percentages (10 and 100 by default). | ||
Line 944: | Line 944: | ||
{{: | {{: | ||
- | Hardkeys allow the user to connect a button or a key to the myCNC controller which will then cause a certain event when pressed/ | + | Hardkeys allow the user to connect a button or a key directly |
* Input Number, which specifies the input to which the hardkey is connected (can be checked in the Diagnostics window) | * Input Number, which specifies the input to which the hardkey is connected (can be checked in the Diagnostics window) | ||
* Pressed/ | * Pressed/ | ||
Line 975: | Line 975: | ||
The following settings are available: | The following settings are available: | ||
* Encoder resolution for each particular encoder number | * Encoder resolution for each particular encoder number | ||
- | * The current encoder value is displayed on this screen | + | * The current encoder value is displayed on this screen. This is the fastest way to check if the encoder is connected/ |
* Z-position is displayed | * Z-position is displayed | ||
- | * Mul coefficients (multiplication) | + | * Mul coefficients (multiplication |
- | * /(2^Div). These Mul and Div coefficients are used due to the fact that the controller cannot handle floating number data in calculations, | + | * /(2^Div). These Mul and Div coefficients are used due to the fact that the controller cannot handle floating number data in calculations, |
* Encoder position | * Encoder position | ||
* Position | * Position |
mycnc/mycnc_configuration_dialogs.txt · Last modified: 2022/10/28 15:51 by ivan