mycnc:mycnc_configuration_dialogs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_configuration_dialogs [2019/11/11 10:07] – ivan | mycnc:mycnc_configuration_dialogs [2019/12/19 11:40] – ivan | ||
---|---|---|---|
Line 1003: | Line 1003: | ||
* Attached to motor flag (has been moved to Analog and Pulse-Dir Close Loop settings in the recent software versions). | * Attached to motor flag (has been moved to Analog and Pulse-Dir Close Loop settings in the recent software versions). | ||
- | More information on encoders is available in the [[mycnc: | + | More information on encoders is available in the [[mycnc: |
===Analogue Closed Loop=== | ===Analogue Closed Loop=== |
mycnc/mycnc_configuration_dialogs.txt · Last modified: 2022/10/28 15:51 by ivan