Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_configuration_dialogs [2019/07/12 15:49] – ivan
+++ mycnc:mycnc_configuration_dialogs [2019/07/15 11:23] – ivan
@@ Line 132: / Line 132: @@
   * Slot can be changed between MPG (to move the spindle around), THC/Z axis offset for manual control of the z-axis during torch height control, or Spindle Sync to synchronize the vertical z-axis movement and the rotation of the spindle.
   * Encoder resolution: number of encoder markings per rotation * number of impulses per marking
+As the ET10 controller has dedicated input ports for manual pulse generators, it is not needed to specify 2 different ports but rather one dedicated encoder port number for an ET10 setup.
 === Jog through ADC inputs ===
@@ Line 186: / Line 188: @@
 ===Connections===
 {{:mycnc:config-connections-inputs-001.png}}
+The connections tab outlines:
+  * the connection source (ADC, DAC, PWM, Input Pin, Input Port, Output Pin, Output Port, Encoder, Global variable, Item, XItem)
+  * source parameter
+  * connection destination
+  * destination parameter
+  * K values (ratio values) K and K0
 ====Network====
@@ Line 206: / Line 214: @@
 ====Motion====
 Upon opening the Motion tab in Settings, you are presented with the following window:
@@ Line 230: / Line 237: @@
 ===Hardware PLC===
 {{:mycnc:config-plc-001-hardware-plc.png}}
+This list presents the available hardware PLC macros, with the ability to add, delete and edit the individual macros as required. After editing the hardware PLC, remember to press the Build All, Save All and Send buttons for the changes to take effect.
-This list presents the available hardware PLC macros, with the ability to add, delete and edit the individual macros as required.
 ===Hardware PLC Templates===
@@ Line 350: / Line 356: @@
   * **Lib storage folder** specifies the folder in which the library parts are stored on the computer.
   * **NC code filename extensions** list the possible extensions that the software will allow the user to open. If an extension is not on the list, it can be added provided it can be read by the myCNC software.
-  * **G04 cycle time** marks the internal controller setting for time marking in order to properly synchronize the controller and the computer.
+  * **G04 cycle time** marks the internal controller setting for time marking in order to properly synchronize the controller and the computer. It should be set
   * The **Disable keyboard Events** setting allows to completely disable keyboard inputs, leaving only the touchscreen.
   * The basic machine profile can be specified to be Mill/Router, Lathe, Cutting Table, or 3D Cutting Table, depending on the user's needs
@@ Line 368: / Line 374: @@
 {{:quickstart:mycnc-quick-start:start-stop-001-preferences-window.jpg}}
-Consult the QuickStart [[quickstart:mycnc-quick-start:start-stop-setup|Start/Stop Setup]] for a full overview of the Start/Stop features.
+The Start/Stop settings specify the behaviour of the machine as the start/stop commands are sent to it. Consult the QuickStart [[quickstart:mycnc-quick-start:start-stop-setup|Start/Stop Setup]] for a full overview of the available features.
 ===Shape Library Settings===