mycnc:mycnc_configuration_dialogs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:mycnc_configuration_dialogs [2019/11/01 09:58] – ivan | mycnc:mycnc_configuration_dialogs [2019/11/11 10:07] – ivan | ||
---|---|---|---|
Line 989: | Line 989: | ||
===Encoders=== | ===Encoders=== | ||
- | {{:mycnc:config-046-encoders.png}} | + | |
+ | {{:mycnc:encoders-008-config.png}} | ||
The Encoders config window allows the user to fine-tune encoder settings. This window is typically not useful for simple tasks (such as using a rotary encoder to control overspeed, etc), as it allows for further finetuning of the encoder values. | The Encoders config window allows the user to fine-tune encoder settings. This window is typically not useful for simple tasks (such as using a rotary encoder to control overspeed, etc), as it allows for further finetuning of the encoder values. | ||
The following settings are available: | The following settings are available: | ||
- | * Encoder | + | * Encoder |
* The current encoder value is displayed on this screen. This is the fastest way to check if the encoder is connected/ | * The current encoder value is displayed on this screen. This is the fastest way to check if the encoder is connected/ | ||
- | * Z-position is displayed | + | * Z-position is displayed |
- | * Mul coefficients | + | * Mul coefficients, as well as / |
- | * /(2^Div). These Mul and Div coefficients are used due to the fact that the controller cannot handle floating number data in calculations, | + | |
* Encoder position | * Encoder position | ||
* Position | * Position |
mycnc/mycnc_configuration_dialogs.txt · Last modified: 2022/10/28 15:51 by ivan