Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_configuration_dialogs [2019/11/11 10:07] – ivan
+++ mycnc:mycnc_configuration_dialogs [2019/11/11 10:09] – ivan
@@ Line 1003: / Line 1003: @@
   * Attached to motor flag (has been moved to Analog and Pulse-Dir Close Loop settings in the recent software versions).
-More information on encoders is available in the [[mycnc:rotary_encoder_connection_and_setup|Rotary encoder connection and setup]] manual which goes through some connection examples.
+More information on encoders is available in the [[mycnc:rotary_encoder_connection_and_setup|Rotary encoder connection and setup]] manual which goes through some connection examples. Additional information on using the ET10 encoder inputs with an MPG wheel is avaialble in the [[mycnc:mpg_through_binary_inputs|MPG through binary inputs]] manual.
 ===Analogue Closed Loop===