mycnc:mycnc_configuration_dialogs
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mycnc_configuration_dialogs [2020/05/14 11:20] – ivan | mycnc:mycnc_configuration_dialogs [2020/05/18 11:04] – ivan | ||
|---|---|---|---|
| Line 393: | Line 393: | ||
| * Command G59 is set to switch the coordinate system to Coordinate System #6 by default. However, if Hypertherm systems are used, Command G59 can be switched to comply with the Hypertherm command style. | * Command G59 is set to switch the coordinate system to Coordinate System #6 by default. However, if Hypertherm systems are used, Command G59 can be switched to comply with the Hypertherm command style. | ||
| * Similarly, Command M50 can be assigned to THC OFF, Feed Override Control or Hypertherm style of commands. | * Similarly, Command M50 can be assigned to THC OFF, Feed Override Control or Hypertherm style of commands. | ||
| - | * Tool Change toggles whether the user can set up the tool change from the main screen of myCNC software. Turn ON to enable tool switching. | + | * Tool Change toggles whether the user can set up the tool change from the main screen of myCNC software. Turn ON to enable tool switching. |
| + | * NOTE: Tool change commands (M6TXX) will NOT be accepted from the G-code if this setting is disabled. | ||
| + | {{: | ||
| * Accept single S-code allows the machine to accept single commands for spindle speed changes on the fly. Not applicable to every configuration. | * Accept single S-code allows the machine to accept single commands for spindle speed changes on the fly. Not applicable to every configuration. | ||
| * G18/G19 Switch re-orients the arcs from clockwise to counterclockwise rotation when drawing. Depending on the CAM software used, different configurations of this setting are required. | * G18/G19 Switch re-orients the arcs from clockwise to counterclockwise rotation when drawing. Depending on the CAM software used, different configurations of this setting are required. | ||
mycnc/mycnc_configuration_dialogs.txt · Last modified: 2022/10/28 15:51 by ivan