Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et10 [2019/02/10 19:51] – skirillov
+++ mycnc:mycnc_et10 [2019/02/10 19:54] – skirillov
@@ Line 92: / Line 92: @@
 ==== ET10 Encoder inputs ====
-ET10 board has 6 Incremental encoder inputs. THere are 4 complete ABC encoder inputs (A/B quadrature encoder signals and Z signal) and 2 reduced AB encoder inputs. ET10 encoder inputs conform RS422 standard and compatible with most of servo drivers and line driver incremental encoders. 34C86 chip is used in ET10 as a receiver of encoder signals. Internal schematic for line driver encoder inputs is shown on a picture below.
+ET10 board has 6 Incremental encoder inputs. There are 4 complete ABC encoder inputs (A/B quadrature encoder signals and Z signal) and 2 reduced AB encoder inputs. ET10 encoder inputs conform RS422 standard and compatible with most of the servo drivers and line driver incremental encoders. 34C86 chip is used in ET10 as a receiver of encoder signals. Internal schematic for line driver encoder inputs is shown on a picture below.
 **INCREMENTAL ENCODER** inputs schematic (1 Encoder, ABC signals are shown)
@@ Line 102: / Line 102: @@
 ==== ET10 DAC +/-10V DAC outputs ====
-ET10 control board contains 6 channel +/-10V DAC outputs. THis outputs can be used fro analgue servo ddrivers closed loop control, spindle speed control or any other application that needed in analogie signals in +/-10V range.
+ET10 control board contains 6 channel +/-10V DAC outputs. This outputs can be used for analogue servo drivers closed-loop control, spindle speed control or any other application that needed in analogue signals in +/-10V range.
 Connectors XT16 and XT5 are used to connect DAC outputs. The connectors pinout are shown in a picture below
@@ Line 133: / Line 133: @@
-Connectors XT20, XT21 are used to connect ADC inputs. The connector pinout are shown below
+Connectors XT20, XT21 are used to connect ADC inputs. The connector pinout is shown below
 {{hardware:et10:et10-connection-adc-001.jpg}}
-The picture below shows an example for potentiometer connected to ADC2 input.
+The picture below shows an example of a potentiometer connected to ADC2 input.
@@ Line 144: / Line 144: @@
 ==== RS422/RS485 Bus ====
-A myCNC-ET10 control board has RS422/RS485 bus connector. Modbus ASCII/RTU and Hypertherm Serial communication interfaces are implemented in a myCNC-ET10 control board.
+Mycnc-Et10 control board has RS422/RS485 bus connector. Modbus ASCII/RTU and Hypertherm Serial communication interfaces are implemented in myCNC-ET10 control board.
 RS422 connector pinout shown below